CNC Angle Punching, Marking and Shearing Machine
CNC Angle Processing Machine
Angle size: 40x40x3~200x200x20mm
Max. Hole size: 26mm
High Speed CNC Plate Drilling Machine
It is mainly used in steel structure drilling in construction, bridge, tower etc., and can be use din pipe and plate of boiler, petro line, baffle plate and round flange.
LEARN MORE
High Speed CNC Angle Drilling and Marking Machine Line
Used for angle steel drilling & marking mainly in the field of angle steel tower industry.
LEARN MORE
CNC H Beam Drilling Machine Line
Used for the drilling processing of H-shape steel, box beam and channel steel of steel structure, bridge, three dimensional garage and petrol platform. It is designed for medium size steel fabricators desiring to increase profitability and throughput (tons-per-month) in today’s extremely competitive market.
LEARN MORE
CNC Plate Punching, Marking and Drilling Machine
Used for punching, drilling and marking joint plates in the field of iron tower. It is also used to punching, drilling and marking metal plate in other industry field.
LEARN MOREMaintenance of CNC angle Punching, Marking and Cutting Machine Machine Line
2017-05-10
Maintenance of CNC angle Punching, Marking and Cutting Machine Machine Line
Proper use of machinery and equipment, maintenance and seriously implement the rules of safe operation is to extend equipment life, a necessary condition to ensure safety in production. Therefore, the operator should first be familiar with the structure of equipment performance and operating procedures. Under the general use of angle steel line maintenance of CNC angle line to make a few for reference.
1) Work wear No. N46 recommended oil hydraulic oil (GB443-84), the hydraulic oil should be, as the temperature. Room temperature below 20 ℃, can wear No. N32 hydraulic oil temperature above 30 ℃, the available N46 or N68 No. resistant No. resistant hydraulic oil hydraulic oil. Using the oil temperature should be 15 ℃ - 55 ℃ range. Since room temperature is different depending on the particular circumstances to use cooler, generally above the fuel tank when the temperature at 45 ℃, open the cooler to cool down.
2) The oil should be strict with 24μ of the oil filter before adding the filter tank. Fuel tank capacity shall not be less than the oil standard requirements.
3) The oil filter should be regularly cleaned with kerosene, the working oil changed once every 2,000 hours of work.
4) The pressure gauge should be checked and calibrated once every six months.
5) Mechanical time disabled, should clean the surface coated with anti-rust oil.
6) Lubrication:
on a cut between the blade and the blade seat, punching mold and punch rod between the injection hole, slide the printer between the frame and rails, and other moving parts into the N46 lubricants should always be a time start re-start should be preceded by oiling.
b screw grease before starting a class.
c drive rack engagement surfaces, the drive chain should always painted ZG-2H synthesis of calcium-based grease (SY1409-76) for lubrication.
d horizontal feed table, turn the first gear rack, etc. before the start of hydraulic oil should be injected into No. N46, should be replaced once every six months the oil inside the reducer.
e drive rack rails should be painted face No. N46 hydraulic oil and a mixture of calcium-based grease for lubrication, recommended that each work week, with oil again.
